SYX MOTO Support Center

Applicable to products: VK 

Applicable to products: VK 

Applicable to products: VK Video guide

Video Instructions: Applies to: Roost PAD125-1F

Instructions:  1. Install the training wheels.  2. Ensure that the bolts and screws are properly tightened. The training wheels should not be loose.  3. ...

Instructions:  1. Remove the bolts.  2. Remove the chain cover.  3. Install the training wheels.  4. Ensure that the bolts and screws are properly tight...

Instructions:  1. Put the front suspension on the bike frame.  2. Tighten up the bolts.  3. Ensure the bolts are tightened up. Video Instruction:  

Instructions:  1. Before the installation, pull slightly to check if the pull starter is functional.  2. Ensure tightened up.  3. Gently pull to check. ...

Tools Required: 4mm Allen Wrench 5mm Allen Wrench 14mm Wrench Instructions: Step 1: Using the 14mm wrench, loosen the nut located at the rear...